Structures Technician (Starship)

SpaceX was founded under the belief that a future where humanity is out exploring the stars is fundamentally more exciting than one where we are not. Today SpaceX is actively developing the technologies to make this possible, with the ultimate goal of enabling human life on Mars. STRUCTURES TECHNICIAN (STARSHIP) RESPONSIBILITIES: Modify, repair, assemble, and install rocket and spacecraft components and subcomponents Align parts and secure in place using clecos or tooling/hand clamps Operate and utilize sheet metal manufacturing equipment such as CNCs, brake presses, and rollers Operate and utilize advanced manufacturing equipment such as robots, welders, and manufacturing software. Perform routine maintenance procedures for up keep on tooling and equipment as required Install mechanical fasteners in correct sequence per drawing, using correct tools (e.g., rivet gun and bucking bar, drill motor, power screwdriver, C-squeeze, ratchet wrench, nut runner) Facilitate and perform component and assemblies testing operations on rocket and spacecraft structures, components and subcomponents (Pressurized testing, cycle testing, fatigue testing, etc.) Shim and/or trim parts as required Select drill bits, reamers and/or countersinking tools for pilot and full-size holes Locate, drill pilot holes using drill motor and proper size drill bit(s) Drill, ream, countersink full size holes in parts/assemblies, in proper sequence and to correct size using drill motor Disassemble parts and deburr holes using chip chasers, deburring tools, and files to prepare for installation of fasteners Use solvents to clean surfaces prior to sealing or assembly Apply sealant, Alodine, primer, adhesives, special finishes Load, lift and unload parts with use of cranes, forklifts, and custom tools Determine and obtain correct type and size fasteners Cold work holes to prepare for close tolerance fastener installation Install bushings into housings using arbor press and/or hydraulic puller Apply liquid nitrogen to facilitate installation of bushings Check work after completion of each operation in job and/or completed job to ensure it is complete per drawing BASIC QUALIFICATIONS: High school diploma or equivalency certificate 1+ years of experience in hardware assembly, test, maintenance, material handling, and/or installation; OR certificate from an accredited trade skills program in A&P, manufacturing, and/or electronics PREFERRED SKILLS AND EXPERIENCE: Experience drilling, reaming, honing and/or countersinking straight and close tolerance holes Experience gained through the military or within an aviation manufacturing company Experience using various types of hand tools and/or hand-held power tools, floor-mounted power tools and precision measuring tools Capable of visualizing a three-dimensional shape from a two-dimensional view and understanding symbols, flag notes, and general notes Ability to perform basic arithmetic calculations accurately (addition, subtraction, multiplication, division, decimals and fractions) Experience making basic layouts on parts or assemblies in order to establish reference points and to check dimensions Experience reading and interpreting engineering drawings, blueprints, and specifications ADDITIONAL REQUIREMENTS: Must be willing to work all shifts, overtime, and weekends as needed. 1st shift: (4:00 AM - 2:30 PM). Must be able to stand for extended periods – 8 hours min Repetitive assembly operations, grasping, standing, lifting, bending, pulling, pushing, stooping, stretching, and carrying are generally required to perform the functions of this position Must be able to lift up to 50 lbs. unassisted COMPENSATION AND BENEFITS: Pay range: Structures Technician/Level 1: $23.00 - $27.00/hour Structures Technician/Level 2: $26.00 - $32.50/hour Structures Technician/Level 3: $31.00 - $38.00/hour Your actual level and base salary will be determined on a case-by-case basis and may vary based on the following considerations: job-related kno